Skip to main content
Budget 2026 and the UK domestic sector: cheaper bills or cheaper homes to run?
Back To All News

Budget 2026 and the UK domestic sector: cheaper bills or cheaper homes to run?

News
16 Nov 26
Dr Jaydeep Bhadra

Budget 2026 set out what the Chancellor called a new course on energy, with cheaper energy as the government's priority and clean power as the way to achieve it. The Budget document is explicit that cheaper electricity will boost electrification and help decarbonise the whole economy. Sam Baptist, CIBSE's Director of Policy & External Affairs has set out what the Budget means for the wider building engineering sector. In this piece, Dr Jaydeep Bhadra, CIBSE's Domestic Sector Technical Manager, ask a narrower question: will the Budget make homes cheaper to run, or only make bills lower for a while? 

The distinction matters. A bill is what a household pays this quarter. The cost of running a home is set by how much energy it needs, how efficiently that energy is converted into warmth and hot water, and when it is used. The first can be changed by a Budget in a day. The second is changed by building interventions.

What the Budget does for bills 

The immediate measures in the Budget are transfers that reduce what households pay: 

  • a £100 payment from January 2027 for households in council tax bands A–D in England (supporting approximately 20 million households), with equivalent funding for the devolved governments 

  • VAT relief on domestic electricity extended to July 2027, worth around £50 per household on the annual price cap 

  • £100m for councils to provide targeted support 

  • Reform on electricity standing charges, with details to be announced next year 

The abolition of gas standing charges, which Ofgem is asked to deliver by the end of 2027, redistributes cost rather than removing it. It is fairer to low-use or efficient households, and it narrows the electricity-to-gas price ratio from 3.3 to 3.0 on Nesta's estimate. These measures are welcome. With bills forecast to rise again in January, households need the relief. But none of them reduces the amount of energy a home needs.

What the Budget does for energy use and costs 

The Budget's longer-term programme is largely about the supply side and the market. It includes: 

  • a Cost Control Framework at the 2027 spending review, with no new policy costs added to bills until it is in place 

  • Prioritising cheaper energy mix and procuring new generation only where it lowers bills, and accommodated in the grid 

  • a consultation on wholesale Contracts for Difference to weaken the link between gas and electricity prices 

The Budget notes that gas set the wholesale electricity price around 60% of the time in 2025, down from around 90% in the early 2020s. That progress is real, and these reforms should push it further. 

The demand side has fared less well: 

  • The Boiler Upgrade Scheme continues with unchanged grant levels, but funding is held at £400m in 2027–28, below the previous trajectory of £709m by 2029–30. 

  • £1bn is cut from Warm Homes Plan capital grants, although most funding for low-income households and social housing is protected. 

  • The government has committed to no major changes to building regulations for the rest of this Parliament, except for safety. Safety related work, including on overheating, continues, and the Future Homes and Building Standards come into force as planned in March 2027. 

The new Warm Homes Loan Scheme is a genuine positive. It offers zero- and low-interest finance that can be combined with grants, and it requires MCS-certified installers. The government's own figures suggest a home with a heat pump, solar panels and a battery could save around £550 a year, rising to around £850 on a time-of-use tariff. Those are savings in running cost, not one-off support. But they depend on installations happening at scale, and on systems performing as designed.

Why the demand side is where homes get cheaper 

Every kWh a home does not need is a kWh that does not have to be generated, transmitted or paid for. Every efficient system means each kWh bought delivers more heat. These savings recur every year, are independent of wholesale prices, and reduce the peak demand that drives network investment. 

Supply-side reform lowers the price of each unit. Demand-side improvement lowers the number of units. A strategy to bring energy costs down for good needs both, and the Budget is currently weighted towards the first. 

The gas standing charge reform shows how the two interact. Moving fixed costs onto the unit rate makes every unit saved worth more, which strengthens the case for insulation and efficient heating. But the reform also makes a low-use gas connection almost free to keep. Without changes to the disconnection process, households that install heat pumps have less reason to leave the gas network. A price signal only reduces costs if households can act on it.

Where engineering makes the difference 

The gap between a policy and a lower bill is closed by design, installation and commissioning. This is where building services engineering matters most. 

Design determines running cost. A heat pump's running cost depends on the seasonal efficiency it actually achieves, which depends on correct heat loss calculation, emitter sizing, flow temperatures, controls and hot water arrangements. Two homes with the same tariff and the same heat pump product can have very different energy use and bills. Tariff reform narrows the gap with gas; design quality decides whether a household lands on the right side of it. 

Performance must be measured. Public money should buy outcomes, not only installations. Commissioning records, in-use monitoring and feedback into design practice are how the sector learns and how consumers gain confidence. 

Comfort is part of cost. Homes that are cheaper to heat must also stay safe in hotter summers. The Future Homes Standards come into force from 24 March 2027 and safety related changes including overheating, will continue during this parliament. Delivering them well, so that homes perform as intended, should be the priority. The review of Part O is central to that as poorly designed homes that overheat create pressure for retrofit cooling, adding cost and demand later. 

Skills and competence underpin delivery. Scaling heat pumps and retrofit depends on a workforce that can design, install and commission systems well. Through its technical guidance for the domestic sector, training and professional registration, and its Domestic Building Services Panel of industry organisations, CIBSE is working to raise competence across the supply chain. Funding certainty is what allows employers to invest in those skills.

What CIBSE is calling for

  1. Put building performance at the heart of plans to cut energy costs. Bills fall for good when homes need less energy and their systems run efficiently. Plans to lower energy costs should recognise this alongside cheaper supply, and CIBSE's members stand ready to help deliver it. 

  1. Give the sector a steady pipeline of work. Predictable support for heat pumps and home upgrades allows businesses to invest in skilled people, training and quality, rather than responding to stop-start demand. 

  1. Make it simple for households to switch fully. When a home moves to a heat pump, leaving the gas network should be straightforward and affordable, so households get the full benefit of the change. 

  1. Make quality the norm. Where public money supports an upgrade, it should be designed, installed and commissioned to recognised guidance by competent professionals. Implement the Future Homes Standard well from March 2027 and continuing the work on the Part O review will help new homes stay efficient and comfortable all year round. 

The government is right that cheaper electricity is the route to lower bills and lower carbon. But cheaper electricity is only half the equation. The other half is homes that need less energy and use it well. That is an engineering task, and the built environment professionals should be ready, and supported to deliver it. 

Sources 

Share this page